HOME

SHOP ORGONE CRYSTALS

528Hz

Vote For Warrior Matrix at Conspiracy Top Sites

daily quote warrior matrix

Follow Us On Facebook
frequency gen soft

 
Post new topicReply to topic
   Warrior Matrix Forum Index -> 528 Hz. DNA Repair Frequency.
View previous topic :: View next topic  
Author Message
key47ar
Member


Joined: 19 Apr 2008
Posts: 33

PostPosted: Sat Sep 03, 2016 2:12 pm    Post subject: frequency gen soft Reply with quote

Hello,
I have the frequency generator soft NCH to generate frequencies. I know that those under 20 hz are not audible. In this soft when I generate a 15hz frequency it is heard, there is something I am doing wrong and I would like to know what it is. Does anyone here know this soft or why this happens?
Thx.,
key
Back to top
View user's profile Send private message
Sensei
Site Admin


Joined: 24 Jan 2005
Posts: 6696
Location: Here Now. Somewhere Else Later

PostPosted: Sat Sep 03, 2016 6:54 pm    Post subject: Reply with quote

15 Hz. is the low end of the human hearing threshold. Some people and babies can hear it. It also depends on what it is being played through and the chosen wave form.

!5 Hz. is a near harmonic of the Schumann resonance (Earth's heartbeat, 7.83 Hz. approximately doubled).

The 15 Hz. zapper chip is readily available, rugged as a moose and rated up to 12 Volts. I have one that has been running 24/7 for over 3 years. The wall mount transformers work very well. I cut the plug off the output end and solder a 9 Volt batter snap that can then be attached to the battery snap (clip) on the zapper.

Sєηѕєι
_________________
Thank you for supporting WarriorMatrix at:
http://www.OrgoneCrystals.com
and
http://www.LemurianCrystal.com
Please, share...
http://www.OrgoniteInfo.com
Back to top
View user's profile Send private message Send e-mail Visit poster's website
key47ar
Member


Joined: 19 Apr 2008
Posts: 33

PostPosted: Sat Sep 03, 2016 8:31 pm    Post subject: nch soft Reply with quote

Hello,
I must do it from the gen soft because I cannot import in my country for this year. Do you have the answer for my question? I purchased from you already but cannot now and need to have this frequency. I know the NCH soft is suitable to generate it but the frequency I generate emits a loud noise I wonder why.
Thx.,
Back to top
View user's profile Send private message
Sensei
Site Admin


Joined: 24 Jan 2005
Posts: 6696
Location: Here Now. Somewhere Else Later

PostPosted: Sat Sep 03, 2016 9:40 pm    Post subject: Reply with quote

What is the link to what you are generating from ?

Sensei
_________________
Thank you for supporting WarriorMatrix at:
http://www.OrgoneCrystals.com
and
http://www.LemurianCrystal.com
Please, share...
http://www.OrgoniteInfo.com
Back to top
View user's profile Send private message Send e-mail Visit poster's website
key47ar
Member


Joined: 19 Apr 2008
Posts: 33

PostPosted: Sat Sep 03, 2016 9:56 pm    Post subject: Reply with quote

http://tone-generator.softonic.com/descargar

Thx.!
Back to top
View user's profile Send private message
masine
Member


Joined: 07 Apr 2010
Posts: 1163
Location: infinite now

PostPosted: Mon Sep 12, 2016 2:11 am    Post subject: Reply with quote

i was there too..
i think your problem is that you selected a SAW or PULSE waveform..
was running an NCH tone gen on 528hz and 15hz from my PC simultaneously.
it was set on SINE WAVEFORM! (the one that looks like this guys mouth - Confused ) any other waveform will make it louder even a TRIANGLE waveform is pretty loud...
for POWER i was using a digital amp (receiver) connected to my PC via external sound card
but its just not the same..
the tone is hitting right and you can feel the vibration on the crystal but i would have to turn the volume up to max or almost maximum to "feel" that SP kick... Rolling Eyes
the zapper on 15hz mode is kicking very well IMO.. enough for small to big sized (0.1 to 10 kilo) Quartz crystals wrapped in a (couple of) Mobius coil ('s.. depending on Xtal size and shape).
i ran out of 9V batteries a long time ago Laughing so i welded a 9V AC adapter to the zappers power input (+/- to +/-)
just like Sensei mentioned and its working 6 years awesomely!
i can still run a 9V battery if i need to use my PW or SP outdoors. i just need to take the AC adapter with me..

but if you would like to run a proper "frequency generator" i recommend a good strong power amp!
the amp will need to work on 2 Ohm! maybe even 4 Ohm if its a good brand.. it is very important or else you will constantly burn your amps! regular amps work with 8 Ohm per output and will shut down or burn if not properly wired or crossed... trust me been there Crying or Very sad
you need to connect the cables when the amp is shutdown and isolate them good!
HZ is another form of electricity and you can get nice good SHOCKS! if your not paying attention...

i had a 2 Ohm power amp when i was making raves 4-5 years ago and i hooked my powered CB to it.
than i ran the NCH soft on my PC at 528/15hz SINE waveform to my asio external audio drive (96khz mode!)
and straight to the power amp. from the power amp to the device my setup for wiring was this:

Left output (+/-) : cables going into SP/PW device.
Right output (+/-) : cables into monitor.

that setup was very potent! i was using only half the power (250W one side) and it was kicking!
the problem was that the monitor was screaming too and it hurts the ears.. so i found an old PC speaker set.
(you know... the plastic stereo crappy made in Korea type of speaker set...)
i plugged the power amp's output cable into the crappy speaker headphones jack by simple welding to a small PL jack (regular headphones) with an extra 25cm cable... + to + and - to - it worked just fine!
so when i wanted to get really funky i lowered the volume on the crappy monitor to almost minimum..
but the power amp was on maximum! (1000W mono bridged)
i could feel it kicking so hard through the double terminated SP i had..

its very extreme to the quartz but i was using a big quartz (1.5 kilo aprox) so it got more "juice" out of it..
but im sure that a big TONE MACHINE like i described here will "dry" a small sized SP more quicker than a zapper will.. eventually you will have to cleanse and refresh your SP more often..
stronger db (volume) current requires a larger crystal... the relations matter IMO...
just like i cant run a 20 kilo Quartz giant crystal wrapped 100 times in Mobius coils and connect this monster to a regular zapper... i can but... the current will drop by cable length..
but if you run a monster like that on a power amp with tone generator soft.. you can give it 1000W 2000W depends on the cables width and material... and make a new freaking ozone layer Laughing

well.. any way.. i wrote more than enough on this subject. this is my humble and honest insight on the subject.
hope i answered your question and shed some light...
you can PM me if you need anymore help
Cool Cool
M.J.
_________________
i am you
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topicReply to topic
   Warrior Matrix Forum Index -> 528 Hz. DNA Repair Frequency. All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum