HOME

528Hz

Vote For Warrior Matrix at Conspiracy Top Sites

daily quote warrior matrix

Follow Us On Facebook
Orgone Home Shield : How To Make
Goto page Previous  1, 2
 
Post new topicReply to topic
   Warrior Matrix Forum Index -> Orgonite Device Construction
View previous topic :: View next topic  
Author Message
mukihr
Member


Joined: 08 Jun 2014
Posts: 38

PostPosted: Tue Jun 10, 2014 5:46 pm    Post subject: Reply with quote

Sensei wrote:
Well, since this crystal is all wrapped, let's do something with it.



Add a little resin, let cure and add some amethyst and a little more resin.





How about a layer of 24 karat gold/resin.



A layer of blue tinted resin with aluminum and brass might be nice.



The final layer is Nano Iron, and Lemurian crystals, lab reduced to nano size.



Wait a few hours and...



Looking down the barrel.


A Home Shield soon to be on the way to it's new Home


Sєηѕєι



ohhhh MAAAN!!!!... so nice....
Back to top
View user's profile Send private message
mukihr
Member


Joined: 08 Jun 2014
Posts: 38

PostPosted: Tue Jun 10, 2014 9:42 pm    Post subject: Reply with quote

a question..... what to do with the wire... connect it to a zapper....?
or just leave it or something??


thank you
Back to top
View user's profile Send private message
revmccoy
Member


Joined: 01 May 2012
Posts: 1112

PostPosted: Tue Jun 10, 2014 9:49 pm    Post subject: Reply with quote

mukihr wrote:
a question..... what to do with the wire... connect it to a zapper....?
or just leave it or something??


thank you


frequency generators, yes.
Back to top
View user's profile Send private message
Ruth
Moderator


Joined: 29 Mar 2010
Posts: 3199
Location: Oregon

PostPosted: Tue Jun 10, 2014 10:32 pm    Post subject: Reply with quote

mukihr wrote:
a question..... what to do with the wire... connect it to a zapper....?
or just leave it or something??


thank you

..............................

Right here: http://www.orgonecrystals.com/store/products.php?cat=25

That's what you need.

Ruth
Back to top
View user's profile Send private message
mukihr
Member


Joined: 08 Jun 2014
Posts: 38

PostPosted: Wed Jun 11, 2014 8:47 am    Post subject: Reply with quote

o.k. guys - that should not be a problem.... freq.generators are not a problem....
...
what if i want to have it with a coil and passive....???? to connect the wire to ground wire of the building... if outside to ground it with an electrode ??? or to just leave the end inside the orgonite material????

......

thank you all...
Back to top
View user's profile Send private message
Sensei
Site Admin


Joined: 24 Jan 2005
Posts: 6480
Location: Here Now. Somewhere Else Later

PostPosted: Wed Jun 11, 2014 9:14 am    Post subject: Reply with quote

mukihr wrote:
o.k. guys - that should not be a problem.... freq.generators are not a problem....
...
what if i want to have it with a coil and passive....????


No problem, it will be a very strong HHG type unit.

mukihr wrote:
to connect the wire to ground wire of the building... if outside to ground it with an electrode ??? or to just leave the end inside the orgonite material????
thank you all...


Never tried, sounds interesting !

Sєηѕєι
_________________
Thank you for supporting WarriorMatrix at:
http://www.OrgoneCrystals.com
and
http://www.LemurianCrystal.com
Please, share...
http://www.OrgoniteInfo.com
Back to top
View user's profile Send private message Send e-mail Visit poster's website
mukihr
Member


Joined: 08 Jun 2014
Posts: 38

PostPosted: Wed Jun 11, 2014 9:35 am    Post subject: Reply with quote

o.k.... will try the TB with that coil i made last night... will post some pictures in a separate thread ... will use pendulum to test it... and also in a few days to come, when i catch some time, will make one with the wire sticking out of the bottom of the TB and will try both of them on the ground - grounded and ungrounded....
Back to top
View user's profile Send private message
mukihr
Member


Joined: 08 Jun 2014
Posts: 38

PostPosted: Wed Jun 11, 2014 10:38 am    Post subject: Reply with quote

found this quote regarding Mobius colils

"How to power them: The orthodox way is to use a low-voltage frequency generator such as Don's Terminator zapper or a software frequency generator such as the NCH toner, but I and others have found these coils to be quite effective used passively (no juice) as long as the circuit is closed i.e. the wire ends connected together. This is very convenient for environmental gifts and sleek wands.
My preference for powering at this time is the earth battery, which in this case is essentially 2 electrodes of different metals, e.g. galvanized conduit pipe and copper pipe, stuck into the earth a couple feet deep. In reasonably moist soil, this usually yields .6 to .8+ volt but with the most wonderful energy quality. After being accustomed to it, the 15hz zapper vibe felt intolerably wimpy and unpleasant to me.
There may be voltage fluctuations, even polarity reversals at times, moreso in some locations than others. A cheap multimeter is needed." ....

i think this is the answer for me and for gifting the Earth... two wires comming out of the TB and into the ground few feet apart connected to electrodes... will be especially nice to do that with a ChemBuster....
Back to top
View user's profile Send private message
Sensei
Site Admin


Joined: 24 Jan 2005
Posts: 6480
Location: Here Now. Somewhere Else Later

PostPosted: Wed Jun 11, 2014 5:21 pm    Post subject: Reply with quote

mukihr wrote:
I think this is the answer for me and for gifting the Earth... two wires comming out of the TB and into the ground few feet apart connected to electrodes... will be especially nice to do that with a ChemBuster....


Yes ! That's the Spirit.

Experiment, adapt, try new things or modify known concepts, then share your experiences.

This is how we learn and grow.

Sєηѕєι
_________________
Thank you for supporting WarriorMatrix at:
http://www.OrgoneCrystals.com
and
http://www.LemurianCrystal.com
Please, share...
http://www.OrgoniteInfo.com
Back to top
View user's profile Send private message Send e-mail Visit poster's website
Aqua Celine
Member


Joined: 14 Jul 2014
Posts: 14
Location: England

PostPosted: Fri Jul 24, 2015 11:32 am    Post subject: Reply with quote

Sensei wrote:
A picture tutorial on Making an Orgonite Home Shield as requested.

I wrap coils around crystals nearly every day and have for years. Here is how to do it.

The wire is stranded 26 Ga. wire. I like this size wire for wrapping small to medium sized crystals. I twisted it counter clockwise with a drill until the wire was at about 45 degree angle and smooth to the touch. The crystal is a Lemurian from Brazil.



Tool of choice (Needed to open a channel under the coil for new wraps to pass through), is a small flat head screwdriver, available at all dollar stores in a pack of mini screwdrivers for about $2). IMPORTANT, when using a small screwdriver you must sand the corners to a slight rounded shape so that it slides smoothly through the wires and does not cut them with a sharp edge.



How much wire is needed ?
As you wrap from the unfinished end to the loop end, the wire has to be the correct length ...or it will either be too short to finish or too long for the crystal. Knowing how much wire to use is essential and can be figured very easily and exactly.

Starting with the loop end of the wire at the top of the crystal wrap the entire crystal in a spiral manner to the end.



This is exactly how much wire that you need. Place a sharp bend in it to mark the end, this will be your starting point. (The End marks the Beginning ?? Just too Zen, lol.)




Holding the crystal in your left hand , with the tip pointed to the left. Secure the loose end(Later to be attached to a frequency generator) with two fingers to keep it tight. The wire on the right is the loose end, the loop end (left) goes OVER the crystal then under towards you.



Continue around the crystal and GO OVER the loose end wire.



Put your tool under the wire. With the tool tip on the crystal face, gently lift the handle forming a channel under the wrap for the wire to pass through. This will become very important as the wrap proceedes and the coil gets tighter.



Pass the loop end under the coil.



After pulling the wire through the coil, again take it OVER the crystal then under towards you.


Go over the coil, over the loose end Then under the coil. Pass the wire over the coil with the loop end going next to the place where it crossed over on the previous wrap, That crossover point is towards you, and will give a flat wrap if correct.







Continue to wrap as before until about 1/2 of the wire is used and it gets difficult to pass the wire under the now growing coil. (or 1/3 of the wire if making a 3 segment coil).

Then take the wire up the crystal, bend it 90 degrees and start another coil, same direction as before.




Cross over where the wire goes straight THEN under to form a new coil segment.











It works the same way for larger crystals.


Continue until the wire is used up and tuck the loop end under the coil and glue it to secure it in place. I use a super glue gel with a spray instant hardener.




It is a Very good idea to then put a shrink tube on the wire snugged up to the coil. This will prevent the wire from breaking at the stress point during use for many years.



Sensei, where's the thread where you posted this home shield build method in which was the topic of the thread? There was a few pages of good info on there, I can't find it anymore. I'm a total novice at electronics and looking to build my first powered pyramid.
Back to top
View user's profile Send private message
Sensei
Site Admin


Joined: 24 Jan 2005
Posts: 6480
Location: Here Now. Somewhere Else Later

PostPosted: Fri Jul 24, 2015 5:15 pm    Post subject: Reply with quote

There is a link somewhere on the web to build your own zapper circuit. Though if you are new to electronics it is Much easier to purchase one already made. The ones we have are proven rugged little units that will run 24/7 for many years and can be run from a 9 volt battery and/or with a wall powered converter. (We have power supplies that will work with wall power in the UK.).

http://www.orgonecrystals.com/store/proddetail.php?prod=nano-zapper-ge nerator

Just clip the Frequency Generator to the wire, no plug needed.

The frequency Generator can also function as a very effective zapper for killing parasites in the body and blood.

Sєηѕєι
_________________
Thank you for supporting WarriorMatrix at:
http://www.OrgoneCrystals.com
and
http://www.LemurianCrystal.com
Please, share...
http://www.OrgoniteInfo.com
Back to top
View user's profile Send private message Send e-mail Visit poster's website
Aqua Celine
Member


Joined: 14 Jul 2014
Posts: 14
Location: England

PostPosted: Fri Jul 24, 2015 6:29 pm    Post subject: Reply with quote

Sensei wrote:
There is a link somewhere on the web to build your own zapper circuit. Though if you are new to electronics it is Much easier to purchase one already made. The ones we have are proven rugged little units that will run 24/7 for many years and can be run from a 9 volt battery and/or with a wall powered converter. (We have power supplies that will work with wall power in the UK.).

http://www.orgonecrystals.com/store/proddetail.php?prod=nano-zapper-ge nerator

Just clip the Frequency Generator to the wire, no plug needed.

The frequency Generator can also function as a very effective zapper for killing parasites in the body and blood.

Sєηѕєι


Thanks. Yes I've seen the vid how to build a zapper on youtube. So, how long would a 9v battery last if I had the zapper on continual use, roughly, please? And what about the DC adapter, I like the sound of that...
Back to top
View user's profile Send private message
Sensei
Site Admin


Joined: 24 Jan 2005
Posts: 6480
Location: Here Now. Somewhere Else Later

PostPosted: Fri Jul 24, 2015 6:44 pm    Post subject: Reply with quote

A fresh alkaline 9 volt battery will power the Frequency Generator 24/7 for 3 to 4 days. Hi quality rechargeable batteries have also been used with good results.

Wall power transformer here:

http://www.orgonecrystals.com/store/proddetail.php?prod=Regulated-Powe r-Supply-220V&cat=13

Easiest for home use.

Sєηѕєι
_________________
Thank you for supporting WarriorMatrix at:
http://www.OrgoneCrystals.com
and
http://www.LemurianCrystal.com
Please, share...
http://www.OrgoniteInfo.com
Back to top
View user's profile Send private message Send e-mail Visit poster's website
YasiraSF
Member


Joined: 08 Oct 2016
Posts: 1

PostPosted: Wed Oct 12, 2016 4:45 pm    Post subject: Reply with quote

I realize this is an old thread, but looking for some clarification.

A zapper is (seemingly) applied directly to a person to have the cleansing effect on parasites.

How would this home shield compare? Since it's being broadcast, would it lead to the same results, simply by being around it?

Thanks!
Back to top
View user's profile Send private message
Sensei
Site Admin


Joined: 24 Jan 2005
Posts: 6480
Location: Here Now. Somewhere Else Later

PostPosted: Wed Oct 12, 2016 10:14 pm    Post subject: Reply with quote

Zappers for blood parasites.

Powered orgonite devices for etheric parasites.

Sєηѕєι
_________________
Thank you for supporting WarriorMatrix at:
http://www.OrgoneCrystals.com
and
http://www.LemurianCrystal.com
Please, share...
http://www.OrgoniteInfo.com
Back to top
View user's profile Send private message Send e-mail Visit poster's website
Display posts from previous:   
Post new topicReply to topic
   Warrior Matrix Forum Index -> Orgonite Device Construction All times are GMT
Goto page Previous  1, 2
Page 2 of 2

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum